Nora Lighting 6" Marquise I, Non-IC New Construction Housing Construction Housing
Dedicated new construction housing for installation in NonIC or insulated ceilings, must specify. Air-tight construction provides energy savings by reducing the flow of air through the ceiling.
Plaster Frame: 0.040 steel frame with integral bar hanger brackets. Brackets can accommodate longer 27ï¾” accessory flat bar hangers. Brackets run along all sides of frame to allow bar hangers to be run parallel or perpendicular to junction box.
Housing: 0.040 aluminum one-piece can. Adjustable ceiling thickness from 3/8ï¾” to 7/8ï¾”.
Air Flow Restriction: Housing has factory installed gaskets to restrict airflow from room into ceiling plenum to <2CFM (cubic feet per minute) in accordance with ASTM-283 Air-Tight requirements.
Bar Hangers: Two 13-3/4ï¾” to 24-1/2ï¾” adjustable bar hangers with captive nails are included on frame. Bar hangers are parallel to junction box, but can be repositioned 90ï¾º perpendicular to junction box if
desired. ï¾“Lï¾” Shaped bar hanger foot to align to bottom of construction joist. A T-Bar notch allow for easy installation in a suspended ceiling.
Junction Box: Prewired 25 cubic inch 0.064ï¾” thick galvanized steel, with seven 1/2ï¾” knockouts, four Romex® pryouts, and snap on covers. All leads are #18AWG wire, the ground wire is connected to the bottom, and quick connectors are supplied on all leads. Through branch circuit wiring, (4-in, 4-out).
Non-IC: Non-Insulated housings require a minimum clearance of 3ï¾” from thermal insulation and 1/2ï¾” from adjacent building components.
IC: Insulated ceiling housings are direct contact rated; no minimum clearance is required.
Input Voltage: 120V or 277V
Delivered Lumens / Wattage:
NHM-612 = 1246lm / 16W
NHM-620 = 1951lm / 26W
Operating Temp.: 0ï¾°C to 75ï¾°C ambient temperature
Comfort Dim: Available in 850-2000lm
LE1: 120V Input; Triac/ELV/0-10V dimming
LE2: 277V Input; 0-10V dimming1
LE4: 120V Input; Triac/ELV/0-10V dimming
Emergency LED Driver (BSL17C-C2)
ï¾· Up to 7.5W emergency illumination with LEDs.
ï¾· Illumination Time: 90min
ï¾· Voltage: 120/277 VAC, 60Hz
ï¾· Output Voltage: 15.0-50.0 VDC
Labels and listings
ï¾· cULus Listed for Damp Location w/ Feed Through
ï¾· cULus Wet Listed (Only with designated trims)
ï¾· Meets or exceeds ASTM-283 Air-Tight Requirements
NHM-612: Non-IC / 1246lm / 16W
NHM-620: Non-IC / 1951lm / 26W