Nora Lighting 4" Marquise II, Non-IC Remodel Housing
Dedicated remodel housing for use in Non-IC or insulated ceilings, must specify. Air-tight construction provides energy savings by reducing the flow of air through the ceiling.
CONSTRUCTIONHousing: 0.040 aluminum housing adjusts to a maximum ceiling thickness of 5/8ï¾” (16mm). Housing terminates at a 1/4ï¾” ceiling flange for even positioning of housing angle within the ceiling. Structural arm consists of 0.050 steel and connects to housing with j-box and ballast. Integral springs brackets provided.
Air Flow Restriction: Housing has factory installed gaskets to restrict airflow from room into ceiling plenum to <2CFM (cubic feet per minute) in accordance with ASTM283 Air-Tight requirements.
Mounting: Four high tension tempered steel springs secure remodel housing to 5/8ï¾” thick (max) ceiling (Hole cutout template provided for convenience).
Junction Box: Prewired 25 cubic inch 0.064ï¾” thick galvanized steel, with five 1/2ï¾”, two 3/4ï¾” knockouts, four Romex® pryouts, and snap on covers. All leads are #18AWG wire, the ground wire is connected to the bottom, and quick connectors are supplied on all leads. Through branch circuit wiring, (4-in, 4-out).
CLEARANCENon-IC: Non-Insulated housings require a minimum clearance of 3ï¾” from thermal insulation and 1/2ï¾” from adjacent building components.IC: Insulated ceiling housings are direct contact rated; no minimum clearance is required.
ElectricalInput Voltage: 120V or 277VLumens / Wattage:NHRM2-415 = 1500lm / 18WOperating Temp.: 0ï¾°C to 45ï¾°C ambient temperatureDimmingLE3: 120V Input; Triac/ELV/0-10V dimmingLE6: 120-277V Input; 0-10V dimming
Labels and listingsï¾· cULus Listed for Damp Location w/ Feed Throughï¾· cULus Wet Listed (Only with designated trims)ï¾· Meets or exceeds ASTM-283 Air-Tight Requirements